Remove the camera board
Make sure the following FRUs (CRUs) have been removed.
"Remove the LCD module" on page 40
"Remove the hinge cover" on page 42
"Remove the LCD bezel" on page 43
"Remove the Hinges" on page 43
"Remove the LCD panel" on page 44
"Remove the microphone rubber" on page 46
Step 1.
Disconnect the camera cable from the camera board and then remove the camera board.
Figure 39. Remove the camera board
Go to
https://support.lenovo.com/partslookup
replacement parts:
Camera board
Removable tape
Remove the LCD cover
Make sure the following FRUs (CRUs) have been removed.
"Remove the LCD module" on page 40
"Remove the hinge cover" on page 42
"Remove the LCD bezel" on page 43
"Remove the Hinges" on page 43
"Remove the LCD panel" on page 44
"Remove the EDP cable" on page 45
"Remove the antenna" on page 46
"Remove the microphone rubber" on page 46
"Remove the ToF rubber" on page 47
"Remove the camera cable" on page 48
"Remove the sensor board cable" on page 48
"Remove the sensor board" on page 49
"Remove the camera board" on page 50
50
Hardware Maintenance Manual
to look up the Lenovo part numbers of the following