Figure 26
1. Anti-scalp roller
2. Spacer
3. Bushing
Figure 27
1. Anti-scalp roller
2. Bushing
Positioning the Seat
The seat can move forward and backward. Position the seat
where you have the best control of the machine and are most
comfortable.
To adjust, move the lever sideways to unlock seat (Figure 28).
G008962
Figure 28
g017628
4. Flange Nut
5. Bolt
g017629
3. Flange Nut
4. Bolt
Using the Drive Wheel Release
Valves
WARNING
Hands may become entangled in the rotating drive
components below the engine deck, which could
result in serious injury.
Stop the engine, remove the key, and allow all
moving parts to stop before accessing the drive
wheel release valves.
WARNING
The engine and hydraulic drive units can become
very hot. Touching a hot engine or hydraulic drive
units can cause severe burns.
Allow the engine and hydraulic drive units to cool
completely before accessing the drive wheel release
valves.
The drive wheel release valves are located behind the seat and
down in the engine compartment.
1. Disengage the PTO (blade control switch) and turn the
ignition key to off. Move the levers to neutral locked
position and apply parking brake. Remove the key.
2. Locate the bypass levers behind the seat, down on the
left and right side of the frame.
3. To push the machine, move the bypass levers rearward
and out to lock them in place as shown in Figure 29.
Repeat this on each side of the machine.
4. Disengage parking brake before pushing.
1
3
23
2
4
g017420
Figure 29