Operating the Ignition Switch
1. Turn the ignition key to the Start position (Figure 16).
When the engines starts, release the key.
Important: Do not engage starter for more than 5
seconds at a time. If the engine fails to start allow
a 15 second cool-down period between attempts.
Failure to follow these instructions can burn out
the starter motor.
Note: Additional starting cycles may be required
when starting the engine for the first time after the fuel
system has been without fuel completely.
2. Turn the ignition key to stop to stop the engine.
Using the Fuel Shut-Off Valve
The fuel shut-off valve is located behind the seat.
Close the fuel shut-off valve for transport, maintenance, and
storage.
Ensure the fuel shut-off valve is open when starting the
engine.
G008947
Figure 16
1
2
G008948
1. On
Starting and Stopping the
Engine
Starting the Engine
1. Raise the ROPS up and lock into place, sit on the seat
and fasten the seat belt.
2. Move the motion controls to neutral locked position.
3. Set the parking brake; refer to Setting the Parking
Brake.
4. Move the blade control switch (PTO) to the Off
position (Figure 18).
5. Move the throttle lever midway between the Slow and
Fast positions.
18
G017428
Figure 17
2. Off