Stopping The Machine; Adjusting The Height Of Cut - Toro 74143 Operator's Manual

To stop, pull the motion control levers to the neutral position.
1. Release the parking brake; refer to Releasing the
Parking Brake in Operation.
2. Move the levers to the center, unlocked position.
3. To go forward, slowly push the motion control levers
forward (Figure 22).
Driving Backward
1. Move the levers to the center, unlocked position.
2. To go backward, slowly pull the motion control levers
rearward (Figure 23).
Figure 22

Stopping the Machine

To stop the machine, move the traction control levers to
neutral and move to locked position, disengage the power
take off (blade control switch (PTO), and turn the ignition
key to off.
G008952
Set the parking brake when you leave the machine; refer to
Setting the Parking Brake in Operation. Remember to remove
the key from the ignition switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.

Adjusting the Height of Cut

Using the Transport Lock
The transport lock has two positions and is used with the
deck lift pedal. There is a lock position and a unlock position
for the transport position. The transport lock is used with the
deck lift pedal. Refer to Figure 24
21
G008953
Figure 23