Table of Contents
Advertisement
Bottle Adapter
Juice Inlet
Locking Latch
5. Slide the locking latch forward. Lift the platform slightly and pull forward to gain access to the electrical connector (see
Figure 22).
6.
Unplug the electrical connector by squeezing the locking tabs on either side and pulling out the connector. Lift and remove the
pump platform (see Figure 22).
Replacing the Tubing
When the pump platform has been removed, replace the tubing by performing the following procedure.
1.
Remove the two white plastic hose clamps from the pump tube connections (See Figure 22) and remove the concentrate
delivery tubes from the hose ends.
2. Loosen and remove the four screws from the pump body (See Figure 23).
© 2022, Marmon Foodservice Technologies Inc.
QUEST ELITE 4 Flavor Installation, Service & Decommissioning Manual
Concentrate
Delivery Tubes
BRIX Adjustment Screw
Figure 39. Interior Details
- 37 -
Water Inlet
Quick Connector
Pump Body Screws
Water Manifold
Pump Motor
Water Solenoid
Front & Rear
Pump Halves
Publication Number:721Q45112MNL
Advertisement
Table of Contents
