Encoder Statistics; Encoder Regions; Privacy Masks - Bosch DINION inteox 7100i IR User Manual

DINION inteox 7100i IR | FLEXIDOME inteox 7100i
4.5.6

Encoder Statistics

This section gives the user information about the bit rate of the device. For each scene, it is
possible to determine the best target/max bit rate through the graphic shown.
Stream
Identifies the current stream.
Zoom
Identifies the current zoom factor of the camera (1x, 2x, 4x, or 8x).
Averaging period
Identifies how often (in seconds, minutes, hours, days or weeks) the encoder time is
synchronized to the actual time.
4.5.7

Encoder Regions

Encoder regions are used to increase or decrease the encoding quality for selectable areas of
the image. They can be used to give better control of the bitrate by enhancing the encoding
quality of important regions (objects) and decreasing the encoding quality of less important
regions (background).
Eight encoder regions can be defined:
1.
2.
3.
4.
5.
6.
7.
4.5.8

Privacy Masks

Privacy Masks block specific areas of a scene from being seen in the camera's field of view.
This can be useful when public spaces are in the coverage area or monitoring will be limited to
a particular zone.
Pattern
Select the color of the mask as it will appear in the live video: Black, Gray, White or
Custom color.
To configure a Privacy mask:
To delete a Privacy mask:
Bosch Security Systems B.V.
Select one of the eight available regions from the drop-down box.
Click the + box to add an area.
Use the mouse to define the area covered by the region.
– Drag the center, corner points, or sides of the shaded area.
– Double-click on a side to add additional points to the area.
Select the encoder quality to be used for the defined area.
If required, select another region and repeat the steps.
To remove a region, select the area and click the waste bin icon.
Click Set to apply the region settings.
– Select the mask number from the drop-down list.
– Click the plus button.
– Adjust the mask in the image:
– Double-click on the edges to add or remove nodes.
– Click and drag the nodes to position them correctly.
– Check the Enabled check box to activate the related mask.
– Click the Set button to apply the related changes.
– Select the mask number from the drop-down list.
– Click the trashcan icon.
– Click the Set button to apply the changes.
User manual
Configuration | en 27
2021-08 | V01 | DOC