Table of Contents
Advertisement
42
en | Configuration
Multicast packet TTL
A value can be entered to specify how long the multicast data packets are active on the
network. If multicast is to be run via a router, the value must be greater than 1.
IGMP version
Set the multicast IGMP version to comply with the device.
Click Set to apply the changes.
Some changes only take effect after the unit is rebooted. In this case, the Set button changes
to Set and Reboot.
4.8.6
IPv4 Filter
Use this setting to configure a filter that allows or blocks network traffic that matches a
specified address or protocol.
IP Address 1 / 2
Enter the IPv4 address that you want to allow or block
Mask 1 / 2
Enter the subnet mask for the appropriate IPv4 address.
Click Set to apply the changes.
4.9
Service
4.9.1
Maintenance
Notice!
Before starting a firmware update, make sure to select the correct upload file.
i
Do not interrupt the firmware installation. Even changing to another page or closing the
browser window leads to interruption.
Uploading the wrong files or interrupting the upload can result in the device no longer being
addressable, requiring it to be replaced.
The camera functions and parameters can be updated by uploading new firmware. To do this,
the latest firmware package is transferred to the device via the network. The firmware is
installed there automatically. Thus, a camera can be serviced and updated remotely without
requiring a technician to make changes to the device on site. The latest firmware can be
obtained from your customer service center or from the download area.
Update server
The address of the update server appears in the address box.
1.
2.
Firmware
To update the firmware:
1.
2.
3.
The new firmware is unpacked and the Flash memory is reprogrammed. The time remaining is
shown by the message going to reset Reconnecting in ... seconds. When the upload is
completed successfully, the device reboots automatically.
Upload history
Click Show to view the firmware upload history.
2021-08 | V01 | DOC
Click Check to make a connection to this server.
Select the appropriate version for your camera to download the firmware from the server.
First, store the firmware file on your hard disk.
Enter the full path for the firmware file in the field or click Browse... to locate and select
the file.
Click Upload to begin transferring the file to the device. The progress bar allows
monitoring of the transfer.
DINION inteox 7100i IR | FLEXIDOME inteox 7100i
User manual
Bosch Security Systems B.V.
Advertisement
Table of Contents
