Encoder Streams; Encoder Statistics - Bosch NDE-8503-R User Manual

FLEXIDOME IP starlight 8000i
4.4.10

Encoder Streams

When this menu is accessed while the device is recording, the following message appears at
the top of the page: "Recording is currently active. At 'Active profile' the stream profile used
for recording is displayed, and overrules the 'Non-recording profile'."
Property
Select one of the resolutions from the drop-down menu for each stream.
Non-recording profile
Select one of the following profiles for each stream:
Profile number
Profile 1
Profile 2
Profile 3
Profile 4
Profile 5
Profile 6
Profile 7
Profile 8
JPEG stream
Set the parameters for the M‑JPEG stream.
–
–
–
Note:
The M-JPEG frame rate can vary depending on system loading.
Click Set to apply the changes.
4.4.11

Encoder Statistics

This section gives the user information about the bit rate of the device. For each scene, it is
possible to determine the best target/max bit rate through the graphic shown.
Stream
Identifies the current stream (1, 2, or JPEG).
Zoom
Identifies the current zoom factor of the camera (1x, 2x, 4x, or 8x).
Bosch Security Systems B.V.
Description
For a high resolution image, the video bit rate and frame quality are
adjusted to ensure that the picture quality is the priority.
For a high resolution image, the video bit rate and frame quality are
adjusted to a median profile for everyday use.
For a high resolution image, the video bit rate and frame quality are
adjusted to ensure that the bit rate is the priority.
For a low resolution image, the video bit rate and frame quality are
adjusted to ensure that the picture quality is the priority.
For a low resolution image, the video bit rate and frame quality are
adjusted to a median profile for everyday use.
For a low resolution image, the video bit rate and frame quality are
adjusted to ensure that the bit rate is the priority.
Ideal for encoding on a DSL uplink where bit rate limitations are critical.
Ideal for encoding on a 3G uplink where bit rate limitations are critical.
Select the Resolution.
– Note: The Resource based option sets the maximum frame rate at the maximum
resolution based on the available system-resources.
Select the Max. frame rate in frames per second (fps).
The Picture quality slider allows adjustment of the M‑JPEG image quality from Low to
High.
User manual
Configuration | en 37
2021-01 | V02 | F.01U.385.211