Table of Contents
Advertisement
Stabilizer Jacks
DO NOT USE THE STABILIZER JACKS TO LEVEL THE RV.
It is important to remember that the stabilizer jacks are to be used only for
support while occupying and moving around the RV. They are not designed to
support the weight of the RV.
The stabilizer jacks must be fully retracted before moving or towing the RV to prevent
stabilizer jack damage.
Each stabilizer jack can be individually adjusted to stabilize the RV for use.
When setting up on soft ground, you may wish to place a wood pad or the equivalent under
each stabilizer jack foot to help keep the jack from sinking into the ground.
Manual Stabilizer Jacks (if so equipped)
1.
To lower each jack, insert the jack crank onto the applicable stabilizer jackshaft.
2.
Turn the crank clockwise to lower each leg until it contacts the ground and stabilizes
the RV.
To raise each jack, insert the jack crank onto the applicable stabilizer jack shaft and turn the
crank counter-clockwise.
Electric Stabilizer Jacks (if so equipped)
Control switches for the stabilizer jacks are typically located on the (door) side of the unit
above the stabilizer jack(s).
To lower each jack, press the control switch until each leg contacts the ground and stabilizes
the unit.
To raise the jack, press the control switch until the jack is returned to the retracted position.
Manual Override
The electric stabilizer jacks may have a built in manual override system. The override
coupler is located on the end of the stabilizer jack opposite the electric motor. One of the
wire motor leads must be disconnected to prevent back loading the motor and causing more
damage.
Disconnect the battery from the system prior to manual operation.
Operation: Insert the 1/2" diameter crank handle inside the coupler. The slot in the end of
the crank handle accommodates the pin inside the coupler to allow manual extension/retrac-
tion of the stabilizer jack. Rotate the handle clockwise to retract and counter clockwise to
extend the jack.
NOTE: The gears can be stripped out if the stab jack is manually re-
tracted/extended to its fullest extent and the operator continues to rotate the
manual override.
Maintenance Record
Section 4: Vehicle Operation
Table of Contents
47
Advertisement
Table of Contents
