Table of Contents
Advertisement
This label has been installed in your recreational vehicle at
the foot end of the Murphy bed. It should not be removed.
Unfolding The Sofa
With the slideout fully extended, unfold the sofa into the flat
position.
Standing at the side of the sofa, grasp the front of
the seat cushion and the top of the back cushion
(A) (arrows).
Lift up on the seat cushion while pulling the top of the back cushion in toward the
seat. The seat and back will form a "V" shape. (B).
Pull the seat cushion out away from the front of the sofa into the flat position (C).
Lowering The Murphy Bed
Unlatch the "D" bolt latches on each side of the bed at
the footboard (in the stored position). This will release
the Murphy bed allowing it to unfold.
Firmly grasp the handle on the footboard of the Murphy
bed, and pull it towards you.
The bed will begin to unfold. Pull it all the way down so
the footboard rests on the floor.
When the bed is in the sleeping position, locate the web
straps with snap hooks on the footboard of the bed (there
is one on each side of the bed). Attach (both) snap hooks
to the metal loops located on the sofa arms. These straps
and loops keep the bed from folding up while in use.
NOTE: The straps are adjustable. They have been installed at a length
that holds the bed securely in place and allows ease of attaching the snap
to the metal loops.
Snap hooks (if present) must be attached to the steel rings on the sofa
arms before using the bed. Failure to attach these snap hooks to the steel
loops on the sofa can result in serious injury or property damage.
Maintenance Record
Table of Contents
Section 12: Interior
155
Advertisement
Table of Contents
