Table of Contents
Advertisement
Closing the beds
Front Bed
1.
Remove the bunk mat from the front bed platform, set aside. Make sure all loose items
have been removed from the bunk mat and bed platform. Items left in these areas may
cause damage to the mats and tent.
2.
Loosen the hinge cover by lifting up on the Velcro side. Lay the cover back on the bed
shelf.
NOTE: The front bunk mat will be the easiest place to store the side and
rear bed bow braces. Starting with the front bed will enable you to take the
bed bow braces off the rear and side and immediately store them. Caution
should be taken to place the bed bow braces in the mat with the curved part
down to prevent the bed bow brace ends from damaging the bunk mat.
3.
Remove the bed bow brace from the ceiling by pushing in on the exposed push-button
and pulling down. Pull the bed bow towards you and remove the "claw" connector
from the curved window bow. Set the bed bow brace aside.
4.
From the exterior, lift the bottom of the tent up exposing the bed platform. Fold the tent
in towards the center of the bed platform.
5.
Make sure the bed tent is pushed in at
least 1" above the side bulb seal.
6.
Lift the bed up and hold it in a vertical
position. Tuck the tent in on both sides.
Make sure the top of the door is clear
from obstructions.
7.
Latch one side of the door.
8.
From the interior, inspect the perimeter
of the door making sure there is nothing obstructing the top and sides of the door. Make
sure the hinge cover is clear of the door.
If the tent or hinge cover is not clear of the door edges, the door
will not close and seal tightly, and/or damage to the bulb seal may
occur.
9.
From the exterior, latch the other side of the door.
10. Place the bed bow brace inside the folded front bunk mat.
11. Place the front bunk mat against the closed front bed plat-
form. Secure it in place by hooking the canvas straps to the
D-ring hasp located above the bed shelf. If needed, adjust the
straps to assure the bunk mat is firmly
secure against the bed platform.
Side Bed (if so equipped): Repeat steps
1 - 9.
10. Place the side bed bow brace in the
folded FRONT bunk mat for storage.
Rear Bed: Repeat steps 1 - 9.
Maintenance Record
Section 4: Vehicle Operation
Table of Contents
61
Advertisement
Table of Contents
