Table of Contents
Advertisement
RETRACT (C) buttons. Select the back arrow (A) to
return to the Device Selection screen
Leveler Operation: Select the LEVELING icon, the
screen opens showing the Leveler Control screen (Fig
7). This screen will allow you to extend and retract
the jacks and to auto level the RV. Press the AUTO
LEVEL button (A) to begin leveling the RV.
Refer to the Lippert User Guide for the One Con-
trol system for more detailed information. Select the
HOME icon (upper right) to return to the Device Se-
lection screen.
Slide-out Operation: Select the SLIDES icon which
will open the Slideout screen (Fig 8). The screen can
display up to 4 slideouts. Slideouts will be numbered
1-4 on the touchscreen. Press Slide 01, and then press
(and hold) the OUT (A) button to extend the slide,
or the IN (B) button to retract it. Repeat this action
on the remaining slideouts. Select the back arrow to
return to the Device Selection screen.
IMPORTANT SAFETY FEATURE: IF SLIDE 01
IS MISSING FROM THE LIST:
This indicates there is a problem with the bedroom
slide-out. In order for the slideout to function
properly, the bedroom door MUST BE OPEN.
An electronic door catch has been installed to the
wall in the bedroom behind the door (Fig 9). A
second piece is mounted to the door (Fig 10). If
the door is closed, the Slide 01 notification on the
touchscreen display will disappear and the slide-
out will NOT operate. When the bedroom door is
opened and the catch pieces connect, the Slide 01
notification appears on the touchscreen display and the slide-out can
then be operated normally.
NOTE: This same safety feature applies to the slide-out switch on the wall
or on the Command Center switch panel. The bedroom door must be open
and the catch pieces connected for the bedroom slide to work.
DSI FLT - Direct Spark Ignition Fault (if so equipped): This light above the GAS water
heater switch on the Command Center panel indicates a problem with the LP portion of the
water heater. When the GAS switch is turned on, the light will blink quickly 3 times and the
water heater will ignite. The light should then stay OFF. If the light comes on and stays
on, it indicates the gas side of the water heater has not fired and there is a problem with the
igniter. There is no water heater switch on the app screen.
Maintenance Record
Section 6: Electrical System
Table of Contents
89
Advertisement
Table of Contents
