Setup; Checking Fluid Levels; Activating And Charging The Battery - Toro Groundsmaster 7210 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
Media and Additional Parts
Description
Operator's Manual
Engine operator's manual
Parts Catalog
Operator training materials
1

Checking Fluid Levels

No Parts Required
Procedure
1. Check the hydraulic fluid level before starting the
engine, refer to Checking the Hydraulic System
(page 52).
2. Check the engine oil level before and after
starting the engine, refer to
Engine-Oil Level (page
3. Check the cooling system before starting the
engine; refer to Checking the Cooling System
(page 45).
Description
No parts required
No parts required
Checking the
40).
Qty.
–
–
Qty.
1 Review before operating the machine.
1 Review before operating the machine.
1
Use to reference part numbers.
1 Review before operating the machine.
2
Activating and Charging
the Battery
No Parts Required
Procedure
Use only electrolyte (1.265 Specific Gravity) to fill
battery initially.
1. Remove the battery from the machine.
Important:
battery is in the machine. You could spill it,
causing corrosion.
2. Clean the top of the battery and remove the vent
caps (Figure
11
Use
Check the hydraulic fluid, engine oil,
and coolant levels.
Activate and charge the battery.
Use
Do not add electrolyte while the
4).