Connecting The Keyboard; How To Log On To The Ultrakey Plus Keyboard; How To Log Off From The Ultrakey Plus Keyboard - Honeywell MAXPRO NVR 3.1 Installation Manual

Table of Contents

S E T T I N G U P T H E M A X P R O N V R

Connecting the Keyboard

Keyboards (all the supported models of MAXPRO NVR) can be connected to MAXPRO NVR

without any configuration.

You can also connect Honeywell's UltraKey keyboard that represents an industry-leading

approach to intelligent, user-friendly control of video management systems. Using the

UltraKey keyboard, you can perform actions such as selecting a panel, PTZ operations,

selecting a video source such as a camera, and others in the Viewer tab.

To connect a Keyboard to MAXPRO NVR

•

First time users of MAXPRO NVR must explicitly logon to UltraKey Plus keyboard in order to

use MAXPRO NVR.

To logon to the UltraKey Plus keyboard

To log off from an UltraKey Plus keyboard

The UltraKey can be connected through the Ethernet. Set the UltraKey IP Address and

System Controller (IP Address of MAXPRO NVR) through the UltraKey configuration

UltraKey manual

settings. Refer to the

Power-on the UltraKey Plus keyboard.

Press the Menu key on the LCD.

Press the MAX-1000 Setup key on the LCD. The Left, Up, Right, and Down buttons

appear on the LCD.

Press the Ent hard key located on the right side of the UltraKey Plus keyboard.

Enter the default PIN password 1234.

Press Ent. The UltraKey Plus keyboard is now ready for use for performing the video

management functions.

Press the Menu key on the LCD.

Press the MAX-1000 Setup key on the LCD. The Left, Up, Right, and Down buttons

appear on the LCD.

Press the Down key.

Press the Ent hard key twice located on the right side of the UltraKey Plus keyboard. The

logoff confirmation message appears.

Press the Ent hard key.

for more information.

MAXPRO NVR 3.1 Commissioning and Installation Guide

Table of Contents