Table of Contents
Advertisement
Installing MAXPRO NVR
Overview
This chapter describes the procedures for installing the MAXPRO NVR software. Follow the
appropriate section in this chapter to complete your MAXPRO NVR software installation.
Caution:
Before you Begin
Be fore you Be gin - Recommended Partition Arrangement
for NVR Serv er
MAXPRO NVR 3.1 Commissioning and Installation Guide
For Honeywell's boxed solutions, MAXPRO NVR XE,SE,PE and MAXPRO
NVR Hybrid XE,SE,PE, the server and client software required is
pre-installed on the box. Hence the instructions in this chapter for Server
software fresh installation are NOT applicable. On the boxes, only the
installation upgrade process might apply depending on the existing
software version on the box. For client workstations, the client installation
procedure is applicable.
•
Ensure that the client and server computers meet the software and hardware
requirements.
•
Ensure that the requirements mentioned in the
section are fulfilled.
•
It is recommended to create a seperate partition of 50GB or higher size for Metadata
storage preferably on the non-OS hard drive in the NVR Server system. Metadata
storage path can be selected during the install and changed from the default path on
the OS partition.
MAXPRO NVR Software Prerequisites
3
39
Advertisement
Table of Contents
