Configure Ip Connection Through Osc - Fujitsu 1FINITY L100 User Manual

Initial System Turn Up
Configure IP Connection to DCN
5.6.3

Configure IP Connection Through OSC

Prerequisite:
■ The NE is installed and powered up, OSC is configured, and DCN connectivity is available through the
transport network using OSC.
Attention: To connect the NE to the DCN through the OSC, the user must first turn up the OSC, which
requires significant OSC provisioning. OSC turn-up is not covered in this chapter because it fits in the
chapter that covers turn-up of the NE transport functions.
The following figure shows a WDM network composed of 1FINITY ROADM and ILA NEs. The NEs at Site A and Site
B connect to the DCN through the LCN1 interface. All other NEs connect to the DCN through OSC links.
Virtuora NC
Virtuora User
NETCONF/
Interface
YANG
DCN
WebGUI
CLI
Remote Users
Figure 91
WDM Network
OSC is required (must be turned up) between every pair of adjacent NEs in the 1FINITY WDM network because it
(OSC) supports various required functions, for example, optical power management and LLDP. If needed, OSC can
carry DCN traffic.
Note: In this procedure, routing instances are configured with OSPF routing protocol. If desired, routing
instances can be configured statically (using the static routing protocol and next-hops).
·
Release 19.1.1 Issue 1.1, May 2021
Site A
Switch
LCN1
Router
1FINITY
LAN cable
ROADM
LAN
1FINITY
LAN
LCN1
1FINITY
Router
ROADM
Switch LAN cable
Site B
1FINITY
ROADM
OSC
1FINITY
ILA ROADM
OSC
OSC
1FINITY
ROADM
176
1FINITY
ROADM
OSC
1FINITY
ILA
Fujitsu and Fujitsu Customer Use Only