Fujitsu 1FINITY L100 User Manual page 67

Unit Description
L100 Blade
Table 18 (Cont.)
Connector and Function
Connector Connector Type
LCN3 SFP cage
LCN4 SFP cage
LMP RJ-45
MAINT RJ-45
MON LC with shutter
OSC LC with shutter
PoE RJ-45
Note: Supported only on
L100 Issue 13,
FC95453R11-I13, and
earlier.
CONSOLE RJ-45
Note: Supported only
on L100 Issue 14,
FC95453R11-I14, and
later.
USB Flash Drive USB 2.0 Standard A
USER RJ-45
UTLP RJ-45
Note: The RST push-switch is used to activate a CPU blade software WARM reset.
·
Release 19.1.1 Issue 1.1, May 2021
Location Function
Front panel 100Base-T/1000Base-T electrical or 1000Base-SX/
LX10/EX/ZX optical interblade communication
connection for blades within one ROADM system
Note: The LCN3 port cannot be used as a
communication connection to another blade or
device outside the virtual NE.
Front panel 100Base-T/1000Base-T electrical or 1000Base-SX/
LX10/EX/ZX optical interblade communication
connection for blades within one ROADM system
Note: The LCN4 port cannot be used as a
communication connection to another blade or
device outside the virtual NE.
Front panel 100Base-T/1000Base-T LMP connection for craft
interface to WebGUI
Rear panel 100/1000Base-T connection of maintenance port (for
Internal use only)
Front panel MON-T and MON-R have 5% (13 dB) splitter
Front panel Optical supervisory channel connection to/from E-SC
E1 port or F-SC E1 port
Front panel 10Base-T/100Base-T power over Ethernet (PoE)
connection (for future use)
Note: The PoE application and cabling is suitable for
indoor use only, and is not suitable for outside
applications.
Front panel RS-232C Serial Interface for CRAFT IF
Front panel Secondary database
Front panel User channel supports maximum 10 Mb/s for both
OC3 OSC and Ethernet OSC (100M/1GE).
Front panel 100Base-T/1000Base-T
Note: Connection to L160 Raman blade.
67
Fujitsu and Fujitsu Customer Use Only