18 SERVICE WORK ON THE ENGINE
18.5
18.6
140
S03626-10
Checking the gear oil level
Info
The gear oil level must be checked when the engine is cold.
S03738-10
Changing the gear oil
Warning
Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.
–
Wear suitable protective clothing and safety gloves.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
–
Position the frame protector.
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
–
Mount the cable ties.
Finishing work
–
Install the air filter box cover. (
–
Install the fuel tank.
(
–
Add 2-stroke oil. (
p. 49)
–
Prime the oil pump.
(
–
Mount the seat. (
p. 72)
–
Install the main silencer. (
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
Main work
–
Remove gear oil level monitoring screw
–
Check the gear oil level.
A small quantity of gear oil must run out of the drilled hole.
»
If no gear oil runs out:
–
Add the gear oil.
–
Mount and tighten gear oil level monitoring screw
Guideline
Screw, gear oil level
monitoring
1
with the washer.
M5
5 Nm (3.7 lbf ft)
p. 73)
p. 79)
p. 135)
p. 76)
p. 62)
1
.
(
p. 142)
1
.
M6
8 Nm (5.9 lbf ft)