Toro 23163 Operator's Manual page 13

3. If you are using the backhoe with a TX traction unit,
install the auxiliary hydraulics clamp as follows:
A. Set the throttle 2/3 of the way to the rabbit position
on the traction unit.
B. Pull the lever and clamp down to the reference bar
so that the clamp routes behind the loader
arm/attachment tilt lever.
1
2
Figure 14
1. Hydraulics lever clamp
C. Set the parking brake and release the clamp so that it
catches under the brake lever (Fig. 15).
Figure 15
1. Hydraulics lever clamp
2. Pin
4. Push the stabilizer control levers forward to lower both
stabilizers until they touch the ground and the front
wheels of the traction unit come off of the ground
slightly.
5. Remove the two pins locking the boom in place
(Figs. 16 and 17) and place them in the storage
positions (Fig. 18).
m–4912
2. Auxiliary hydraulics lever
m–4913
3. Auxiliary hydraulics lever
13
Note: One pin prevents the boom from swinging side to
side (Fig. 16) and the other prevents the boom from moving
up and down (Fig. 17).
Figure 16
1. Pin
1
Figure 17
1. Pin
Figure 18
1. Pin
1
m-?
m-?
1
2
m-?
2. Lynch pin