SMC Networks EZ Connect SMCWEB-N User Manual page 52

has an LED, and the LED will start flashing if the button is pressed. The LED on the router will turn solid ON if
the device has been successfully added to the network. If something goes wrong during configuration, the
flashing pattern of the LED changes.
There are several ways to add a wireless device to your network. Access to the wireless network is controlled
by a "registrar". A registrar only allows devices onto the wireless network if you have entered the PIN, or
pressed a special Wi-Fi Protected Setup button on the device. The router acts as a registrar for the network,
although other devices may act as a registrar as well.
After the device is in WiFi Protected Setup configured state, holding the button for more than 5 seconds will
reset the device to unconfigured state, and the device will discard the current wireless security settings and
will start to run WiFi Protected Setup protocol to find the new security settings.
Set UP Wireless Wizard
Start the wizard.
48