Installation Considerations; Getting Started - SMC Networks EZ Connect SMCWEB-N User Manual

Installation Considerations

The SMCWEB-N lets you access your network, using a wireless connection, from virtually anywhere within
its operating range. Keep in mind, however, that the number, thickness and location of walls, ceilings, or
other objects that the wireless signals must pass through, may limit the range. Typical ranges vary
depending on the types of materials and background RF (radio frequency) noise in your home or business.
The key to maximizing wireless range is to follow these basic guidelines:
1 Keep the number of walls and ceilings between the SMCWEB-N and other network devices to a
minimum - each wall or ceiling can reduce your
meters.) Position your devices so that the number of walls or ceilings is minimized.
2 Be aware of the direct line between network devices. A wall that is 1.5 feet thick (.5 meters), at a
45-degree angle appears to be almost 3 feet (1 meter) thick. At a 2-degree angle it looks over 42
feet (14 meters) thick! Position devices so that the signal will travel straight through a wall or ceiling
(instead of at an angle) for better reception.
3 Building Materials can impede the wireless signal - a solid metal door or aluminum studs may have
a negative effect on range. Try to position wireless devices and computers with wireless adapters
so that the signal passes through drywall or open doorways and not other materials.
4 Keep your product away (at least 3-6 feet or 1-2 meters) from electrical devices or appliances that
generate extreme RF noise.

Getting Started

For a typical wireless setup please do the following:
1. Select desired operation mode using the slide switch on the back panel. AP mode
configures the SMCWEB-N to function as a wireless access point. Client mode
configures the SMCWEB-N to function as an Ethernet to wireless bridge. Client mode
is used for connecting Ethernet devices such as a game console, digital media player
or Network Attached Storage. You can directly connect up to 4 devices. Note: The
default mode is AP.
2. Using the yellow RJ-45 cable connect port LAN1 on the SMCWEB-N to your network
or Ethernet client device(s). Now connect the power supply. Ethernet LAN ports of the
SMCWEB-N are Auto MDI/MDIX and will work with both Straight-through and
Cross-Over cable.
3. To access the default management IP address your PC must have an IP address in
the range 192.168.2.3~254, with subnet mask 255.255.255.0.
4. Start web browser and enter address
enter password smcadmin then click [Log In]. Note: The User Name must be set to
Admin.
5. Click [Wireless Network Setup Wizard] and follow the on screen instructions to
complete the set-up and reboot.
wireless product's range from 3-90 feet (1-30
http://192.168.2.2 (default). When prompted
7