PARKING DISTANCE CONTROL
7
10
Adjustment
– With the vehicle stopped, press the 7
switch as many times as required to
reach the "Vehicle" tab;
– press the 8 or 9 control repeatedly to
reach the "Settings" menu. Press the
switch 10 OK;
– press the 8 or 9 control repeatedly
to reach the "PARKING ASSIST"
menu. Press the switch 10 OK;
2.126
(6/8)
– select "Beep volume" to adjust the
volume of Park Assist using control 8
or 9.
Automatic deactivation of the
parking distance control
The system deactivates:
– when the vehicle speed is above ap-
proximately 6 mph (10 km/h);
8
– depending on the vehicle, when the
vehicle is stationary for more than
approximately three seconds and an
9
obstacle is detected (such as when
in a traffic jam etc.);
– when you are in N or P position;
– when an operating fault is detected.
Note: if the vehicle is fitted with a
towbar recognised by the system, only
the rear Park Assist is deactivated.
Deactivating the parking
distance control manually
You must disable the function if:
– if towing, carrying or trailer equip-
ment that is unrecognised by the
system is present in front of the ul-
trasonic sensors;
– in the event of damage to the ultra-
sonic sensors.
Operating faults
When the system detects an operating
fault, a beep sounds for approximately
three seconds each time reverse gear
is selected and is accompanied by
the message "Check parking sensor"
shown on the instrument panel. Consult
an approved dealer.