Renault KANGOO Vehicle User Manual page 226

TYRE PRESSURE MONITOR
1
5
4
Resetting procedure via the
instrument panel 1
Ignition on, vehicle stopped:
– repeatedly tap the 5 switch as many
times as necessary to reach the "ve-

hicle" tab ;
– briefly press the 2 or 3 switch to
reach the "Tyre Pressure" page;
2.24
(2/5)
– press and hold (around 3 seconds)
the button 4 to launch the reset. The
flashing tyres followed by the mes-
sages "Learning Tyre Pressures"
and then "Tyres location in progress"
indicates that the reset request for
the tyre pressure reference value
has been acknowledged.
Reset can take several minutes of driv-
ing.
2 If the resetting is followed by short
trips, the message "Tyres location in
progress" can remain displayed after
successive restarts.
3
Note: the standard tyre pressure
cannot be less than that recommended
and indicated on the door frame.
6
Resetting procedure via the
multimedia screen 6
Please refer to the multimedia instruc-
tions for further information.
For your safety, the warning
®
light requires you
to stop immediately as soon
as traffic conditions allow.