SATO RWG500 Quick Manual page 18

Label Setup (cont'd)
To change the rewind direction, use the Direction switch
found on the side panel of the rewinder. The factory set-
ting is CW rewinding by default.
Setting Rewind Direction
1. Before changing the rewind direction, make sure
the rewinder is turned OFF, or make sure that the
Status LED is blinking in green (rewinder in Idling
state)
2. Locate the Direction switch at the side panel, and
set it to either CW (clockwise, face in) or CCW
(counterclockwise, face-out).
3. Check the control panel display to confirm that the
appropriate CW or CCW LED is lit.
Caution
Change the rewind direction only when the rewinder is in
an idling state, or when it is turned OFF.
18