Volvo XC90 TWIN ENGINE Owner's Manual page 495

three programmable buttons and one indicator
lamp in the mirror glass.
For more information about HomeLink
www.HomeLink.com, www.youtube.com/
HomeLinkGentex or call the toll-free number
00 8000 466 354 65 (or the toll number
11
+49 6838 907 277) .
Save the original remote controls for future pro-
gramming (e.g. when changing to another car or
for use in another vehicle). It is also recom-
mended that the programming for the buttons is
deleted when the car is sold.
Related information
•
Using HomeLink (p. 495)
•
®
Programming HomeLink * (p. 493)
•
®
Type approval for HomeLink
9 Applies to certain markets.
10 HomeLink and the HomeLink house symbol are registered trademarks of Gentex Corporation.
11 Note that the toll-free number may not be available depending on operator.
Applies to certain markets.
12
Programming HomeLink
Follow these instructions to program
®
®
, visit HomeLink
individual buttons.
NOTE
In certain vehicles the ignition must be
switched on or in "accessory position" before
HomeLink
possible, fit new batteries in the remote con-
trol that shall be replaced by HomeLink
faster programming and improved transmis-
sion of the radio signal. The HomeLink
tons should be reset before programming.
WARNING
* (p. 496)
While programming HomeLink
door or gate being programmed may activate.
For this reason, make sure that nobody is in
the vicinity of the door or gate while program-
ming is in progress. The car should be outside
the garage while a garage door opener is
being programmed.
®
* 12
, reset all programming or reprogram
®
can be programmed or used. If
®
for
®
but-
®
, the garage
STARTING AND DRIVING
1. Aim the remote control towards the
®
HomeLink button to be programmed and
hold it approx. 2-8 cm (approx. 1-3 inches)
from the button. Do not obstruct the indicator
®
lamp on HomeLink .
Note: The ability of some remote controls to
®
program HomeLink is improved at a dis-
tance of approx. 15-20 cm (approx. 6-12
inches). Bear this in mind if you encounter
problems during programming.
2. Press and hold depressed both the button
on the remote control and the button to be
reprogrammed on HomeLink
®
.
}}
493
* Option/accessory.