Volvo XC90 TWIN ENGINE Owner's Manual page 304

DRIVER SUPPORT
Head-up display for Adaptive Cruise
Control if there is a risk of collision
In cars equipped with a head up display*, the
warning is shown on the windscreen by a flash-
ing symbol.
Symbol for collision warning on the windscreen
NOTE
Strong sunlight, reflections, extreme light con-
trasts, the use of sunglasses, or if the driver is
not looking straight ahead may make the vis-
ual warning signal in the windscreen difficult
to recognise.
Related information
•
Adaptive Cruise Control* (p. 298)
44 NOTE: The illustration is schematic - details may vary depending on car model.
Adaptive Cruise Control
45
302
Activating and starting Adaptive
Cruise Control
Adaptive cruise control (ACC
activated and then started if it is to control the
speed and distance.
Setting the adaptive cruise control in
standby mode
44
.
NOTE: The illustration is schematic - details may vary
depending on car model.
Immediately after the engine is started the Adap-
tive Cruise Control is in the standby mode. To set
it in standby mode from active mode, proceed as
follows:
Press steering wheel button ◀ (2) or ▶ (3) to
45
–
) must first be
scroll to the symbol/function
> The symbol is displayed and Adaptive
Cruise Control is set in standby mode.
Starting/activating the adaptive cruise
control
In order to start the ACC the following require-
ments apply:
•
The driver's seatbelt must be buckled and
the driver's door must be closed.
•
There must be a vehicle (the "target vehicle")
within reasonable distance in front of the car,
or the current speed must be at least
15 km/h (9 mph).
•
For cars with manual gearbox. Speed must
be at the lowest 30 km/h (20 mph).
(4).
* Option/accessory.