Compactflash (Cf) Card Recording; Recording; Message Program/Sentence Composition Example - Toa SV-200M Instruction Manual

27. COMPACTFLASH (CF) CARD RECORDING

27.1. Recording

• Use TOA's EV-350R Digital Announcer for CF card recording.
• The table below shows an example of Program/Sentence composition for Messages 1 – 8.
[Setting items and contents]
(1) Set the items in "Program No." (P001 – P008) and "Playback method" columns as shown in the table.
Besides, be sure to set the "Busy output (at repeat interval)" (omitted in the table) for ON (factory-preset).
(2) The contents in "Number of repeats", "Repeat interval", and "Sentence No. (or Silent Section)" are given
for an example.
(3) Determine the optimum "Output level" for each Program by performing the operation.
(Factory-preset level: Graduation 6)
Note: The VM amplifier ignores the following settings programmed by the EV-350R.
(1) Program title, Sentence title
(2) Output (1 and/or 2)
(3) The setting contents to be registered in the EV-350R unit, not in the CF card. (See the item marked
(* 2 ) in the "Summarized Operational Functions" on page 15 of the "EV-350R OPERATING
INSTRUCTIONS.")
Refer to the "Digital Announcer EV-350R Operating Instructions" for terminologies and recording method.
[Usable CF Cards (their card adapter required)]
• Use the "SanDisk"* CompactFlash* (CF) card.
Required card capacity (16 - 96 MB) depends on the recording time and sound quality. For reference, see
the card capacity vs. recording time table on page 8 of the "EV-350R OPERATING INSTRUCTIONS."
Be sure to keep 10-second or longer unrecorded portion on the card because it is used for controlling the
EV-200 board's surveillance function.
• Place the CF card in the CompactFlash card adapter, then insert the adapter into the memory card slot on
the EV-350R's front panel.
* Trademark of SanDisk Corporation
Caution
• When the EV-200 is mounted, never move the unit from one place to another with the Flash Card inserted
because the EV-200 or the CompactFlash card may fail.
• Avoid inserting or withdrawing the CompactFlash card while the unit is alive.

27.2. Message Program/Sentence Composition Example

VM unit's Program
Message No. No.
Message 1 P001
Message 2 P002
Message 3 P003
Message 4 P004
Message 5 P005
Message 6 P006
Message 7 P007
Message 8 P008
Playback Number
method of repeats
Continuous ––
Program ––
Playback ––
––
––
Repeat 5 times
Playback Endless
Continuous ––
Program
Playback
Repeat Sentence No.
interval (or Silent Section)
–– A001, A002, M003, A003
–– A011, A012, M002, A013
–– A021, A022, M002, A023
–– A031
–– A041
0 second A051, M001, A052, M002
0 second A061, M001, A062, M002
–– A071
Remarks
Activation from
Remote Microphone
or Message
activation input
(CONTROL I/O)
Alert message
Evacuation message
Pre-recorded chime
53