System Configurations; Remote Microphone/Vm Amplifier Configuration (The Number Of Connected Units); Remote Microphone Operation Panel Function - Toa SV-200M Instruction Manual

7. SYSTEM CONFIGURATIONS

7.1. Remote Microphone/VM Amplifier Configuration
(The Number of Connected Units)
Set the total number (0 – 5) of equipment (up to 1 sub-VM amplifier and up to 4 RM-200M Remote
Microphones) connected to the master VM amplifier using the master VM amplifier's internal DIP switches
SW3-No. 6, No. 7 and No. 8 "No. of connected units." Note that these switches in the sub-VM amplifier are not
used.
Remote
microphone
No. 1
The number of Remote Microphones (0 – 4 units)
Set the Remote Microphone's Unit number (1 – 4) using DIP switches No. 1 and No. 2 on the microphone's
right side panel. The Unit number may be set regardless of the unit's connection order. (See p. 40 "VM
Amplifier's Internal Function Switches.")

7.2. Remote Microphone Operation Panel Function

The Zone/Message selector key function differs depending on the connected VM amplifier as described
below.
(1) 5 speaker zones with 1 VM amplifier
Remote
microphone
RM-200M
(2) 5 speaker zones with 1 VM amplifier (equipped with the EV-200 Board)
Remote
microphone
RM-200M
14
Remote Remote
microphone microphone
No. 2 No. 3
Zone 1 – 5
selector key/indicator
Zone 1 – 5
selector key/indicator
Message 1 – 5
selector key/indicator
Master VM
Remote
amplifier
microphone
No. 4 EV-200
Voice
announcement
board (optional)
VM amplifier
VM amplifier
Sub-VM
amplifier
Sub-VM amplifier
(0 or 1 unit)
Voice announcement
board EV-200