Vm Amplifier's Internal Function Switches; Remote Microphone's Function Switches - Toa SV-200M Instruction Manual

23.2. VM Amplifier's Internal Function Switches

The switches must be set by a qualified service technician only.
Each of the following functions can be selectively set with the switches.
For the switch setting method, consult the shop from whom the unit was purchased.
Priority levels (Underlined priority levels represent factory-preset levels.)
Function Inputs 1 – 3
Broadcast Priority Level
Input 1 Input 2 Input 3
1
Selectable
2
Priority modes, Unit type, and Number of units (Underlined settings represent factory-preset settings.)
Function First/Last
Priority
First-come
first-served
Selectable
Last-come
first-served
BGM broadcast volume attenaution level (Underlined level represents factory-preset level.)
Function BGM broadcast volume attenuation
No attenuation
Selectable –28 dB (just audible)
– ∞ dB (inaudible)

23.3. Remote Microphone's Function Switches

1 2 3 4 5 6
ON
Switch No.
Function RM Unit No.
(See the RM Unit No.
ON table below.)
OFF
* One of 2 priorities can be set for each Remote microphone. (See p.26 "GENERAL-PURPOSE
BROADCAST PRIORITY.")
RM (RM-200M) Unit No. table
Switch No.
RM Unit No.
1 2
ON ON
OFF ON
ON OFF
OFF OFF
All switches No. 1 – 6 are factory-preset to the ON position.
40
TEL Paging
Priority Level
1 1
2 2
Priority 2 Mode after
Mixing Emergency Talk
Mixed
Not mixed Evacuation
message
Function setting switch (No.29)
1 2
No. 1
No. 2
No. 3
No. 4
Voice Announcement Board's
Message Priority Level
Message 3 Message 4 Message 5
1 3
2 1
Input 3/LINE
(Input 3/MIC)
Chime On/Off
Silent On
(off)
Off
(on)
Note
The switch is actually installed upside down.
3
Broadcast Talk key
Priority* operation
2 Press-to-talk
type
1 Talk lock type
3 3
1 1
Unit Type No. of Connected
Units
Sub-unit 0 through 5
Master
unit
4 5
Emergency
switch
Enable
Disable
Priority Mode
for Same
Priority Unit
Unit No. Priority
(Numerical order)
First/Last
Priority
6
Compressor
On
Off