Target Group; Instructions Before Installation - Dometic MWE9104 Installation And Operating Manual

• Zone 3 (MWE9104 only)
Nearly all objects are displayed in this zone, but some objects may end up in the blind spot of the sensors.
• Zone 4 (STOP zone)
If there are objects in this area, the parking aid warns with a continuous tone and prompts the driver to stop the
vehicle. The distance can be adjusted in stages.
Nearly all objects are displayed in this zone, but some objects may end up in the blind spot of the sensors.
Rear system (MWE9104)
The detection range of the rear system is divided into four zones
Front system (MWE9104F)
The detection range of the front system is divided into three zones
Control elements
The control electronics for the sensors have the following control elements:
No. in Designation
Fig.  on
page 3
1 Display
2 Right setting button
3 Le setting button

9 Target Group

The mechanical and electrical installation and setup of the device must be performed by a qualified tech-
nician who has demonstrated skill and knowledge related to the construction and operation of automotive
equipment and installations, and who is familiar with the applicable regulations of the country in which the
equipment is to be installed and/or used, and has received safety training to identify and avoid the haz-
ards involved.

10 Instructions before installation

FS Factory settings activated
CS Customized settings activated
Fig.  on page 3 .
Fig.  on page 3 .
EN
7