Steps For Finalizing The Installation - Travis Industries 864 HO NB GSR2 Installation Manual

36

Steps for Finalizing the Installation

1. Remove the glass frame (see page 38).
NOTE: If using propane (LP) convert the appliance prior to installing the logs.
2. We recommend you purge the gas line at this time (with the glass frame removed). This allows gas
to be detected once it enters the firebox, ensuring gas does not build up.
3. Make sure the two accent light bulbs are in place.
NOTE: Take care to not touch the bulb with your fingers (use a cloth or paper towel).
4. Install the required firebacks (see page 41).
5. Install the burner and media (logs or stones). See the instructions included with the burner and
media.
6. Replace the glass frame.
7. Install the four AA batteries (see illustration below). The AA batteries act as a power backup in case
the household (AC) power goes out and are required for operation.
the remote (see illustration below). Synchronize the transmitter to the IFC (see the owners manual).
© Travis Industries
Installation
(for qualified installers only)
4140922
Install three AAA batteries into
100-01410