Location 243 Programming The Zones - Interlogix NetworX NX-1701E Installation Manual

Segment 2 LED1 (Green) Options:
LED1 - "On" to follow Ready status of system. (Default is "On")
LED2 - "On" to toggle with the open collector output activation. (Default is "On")
LED3 - "On" if inverted.
LED4 - Reserved.
LED5 - Reserved.
LED6 - Reserved.
LED7 - Reserved.
LED8 - Reserved.
Segment 3 LED2 (Red) Options:
LED1 - "On" to follow Armed status of system. (Default is "On")
LED2 - "On" to toggle with the open collector output activation.
LED3 - "On" if inverted.
LED4 - Reserved.
LED5 - Reserved.
LED6 - Reserved.
LED7 - Reserved.
LED8 - Reserved.
Segment 4 Reader Partition:
LED1 - "On" if reader is in Partition 1. (Default is "On")
LED2 - "On" if reader is in Partition 2. (Default is "On")
LED3 - "On" if reader is in Partition 3. (Default is "On")
LED4 - "On" if reader is in Partition 4. (Default is "On")
LED5 - "On" if reader is in Partition 5. (Default is "On")
LED6 - "On" if reader is in Partition 6. (Default is "On")
LED7 - "On" if reader is in Partition 7. (Default is "On")
LED8 - "On" if reader is in Partition 8. (Default is "On")

Location 243 Programming the Zones

(2 segments of numerical data)
Segment 1 Door Shunt Zone
Program the zone that will be monitored as a door for access control. This location must be programmed with a valid
zone for monitored access control functions to work properly. (Default is 0)
Additionally, this zone must be configured in the control panel as an "access control" zone by
programming an unused Zone Type Characteristic in locations 111-169 (Seg 4, Opt 4).
Segment 2 Request To Exit (RTE) Zone
Program the zone that will be monitored to signal an RTE. If this segment is programmed with a valid zone and the
zone is faulted, the reader will activate its onboard open collector output and send the RTE. (Default is 0)
Additionally, this zone must be configured in the control panel as an RTE zone by programming an unused
Zone Type Characteristic in locations 111-169 (Seg 4, Opt 3).
NX-1701E Installation manual Page 12 31/01/05