Adding One User; Adding Multiple Users With Auto-Increment - Interlogix NetworX NX-1701E Installation Manual

Adding One User

[ ]
STAY
[
3-digit user number
if 4-digit user code
Example:
or if 6-digit user codes
Scan the card designated for the user
entered in the previous step.

Adding Multiple Users with Auto-Increment

[ ]
CANCEL
[
3-digit user number
if 4-digit user code
Example:
or if 6-digit user codes
Scan the card designated for the user
entered in the previous step.
Continue scanning user cards until the
desired number of cards has been added.
By default, user cards are added and activated. In order to add a user card and
de-activate it at the same time, scan and hold the card to be added until two
beeps are sounded at the reader.
NX-1701E Installation manual
ACTION
]
ACTION
on NX-148E; use [NIGHT] on NX-1248E
]
Page 8
RESULT
Accesses Activation mode
If a valid user number is entered, LED1 on any
enabled readers will begin to flash.
1) If the user card is not already in the system, it
will be added and mapped to the entered user
number.
2) If the card is already in the system, the reader
will triple beep and LED1 will continue flashing;
the user number is not incremented in this case.
RESULT
Accesses Activation mode
If a valid user number is entered, LED1 on any
enabled readers will begin to flash.
1) If the user card is not already in the system, it
will be added and mapped to the entered user
number and LED1 will continue flashing
indicating that the next user card can be
scanned for the next user number.
2) If the card is already in the system, the reader
will triple beep and LED1 will continue flashing;
the user number is not incremented in this case.
After about 30 seconds without a card being
scanned, all the readers in the system will be
updated with the new user card information.
31/01/05