Table of Contents
Advertisement
Programming a Location
If an attempt is made to program an invalid entry for a particular segment, the keypad
sounder will emit a triple error beep (beep, beep, beep), and remain in that segment
awaiting a valid entry.
To Enter a Location:
[location] #
To Change Location Data:
[changed data]
NOTE: Repeat these steps until the last
segment is reached.
To Exit a Location:
#
To Review The Data:
[location] #
Shortcuts:
Exiting the Program Mode:
EXIT EXIT
NX-1701E Installation manual
The Armed LED will flash. If the location is valid, the
"Armed" LED will extinguish, the "Ready" LED will
illuminate, and the zone LED's will show the data for
the first segment of this location.
The "Ready" LED will flash to indicate a data change
in process and will continue until the data is saved.
The new data is saved.
The keypad will increment and display the next
segment's data.
Exits from this location. The "Ready" LED will
extinguish. The "Armed" LED will illuminate waiting
for a new programming location to be entered.
The Armed LED will flash. If the location is valid, the
"Armed" LED will extinguish, the "Ready" LED will
illuminate, and the zone LED's will show the data for
the first segment of this location.
(Do not enter data.)
The next segment is displayed. Each time
pressed, the data of the next segment will be
displayed for review.
Previous location.
Same location.
Next sequential location.
Exits this programming level.
Page 6
is
31/01/05
Advertisement
Table of Contents
