Programming Locations; Location 0 Programming The Scan Functions; Locations 1 - 240 Reserved; Location 241 Programming The X-10 Address For The Scan Functions - Interlogix NetworX NX-1701E Installation Manual

Proximity card reader

Hide thumbs

Table Of Contents

Table of Contents

SCAN METHODS: Legacy mode is default. Alternative mode is shown below in brackets { }.

Refer to Location 242 Segment 1 on page 11, and the Glossary on page 23 for explanation.

Location 0

Programming the Scan Functions

(3 segments of binary data) Location 0 is used to select the particular function(s) that are activated when a card is

scanned. More than one function may be selected. If more than one function is selected, they will execute in order

from function 1 to function 8.

Functions 1-6 will be performed based on the user's authority as programmed by the [ ] [6]

function (refer to keypad user manual).

Segment 1

Single Scan Function {Single Beep}

Program the functions that are performed when a card is scanned {one beep}.

"On" to send Code Entry function to the control panel.

LED1 -

"On" to activate the Armed Away mode.

LED2 -

"On" to activate the Armed Stay mode.

LED3 -

"On" to send the Disarm function to the control panel.

LED4 -

"On" to send Auxiliary Function #1 to the control panel.

LED5 -

"On" to send Auxiliary Function #2 to the control panel.

LED6 -

"On" to broadcast an X-10 function (see Location 241 for programming).

LED7 -

"On" to send a Request To Exit (RTE); and activate the onboard open collector output. (Default

LED8 -

is "On")

RTE to be sent.

Segment 2

Double Scan Function {Double Beep}

Program the functions that are performed when a card is scanned twice within the 2 Scan Hold Time {two beeps}.

Location 244, Segment 1 programs the length of time between beeps. The descriptions of the options are the same

as for Single Beep Scan Function. Default is 1.

Segment 3

Single Scan Hold Function {Triple Beep}

Program the functions that are performed when a card is scanned and held at the reader for the duration of the 2

Scan Hold Time {three beeps}. Location 244, Segment 1 programs the length of time between beeps. The descriptions

of the options are the same as for Single Beep Scan Function. Default is 1.

Locations 1 - 240

Location 241 Programming the X-10 Address for the Scan Functions

(5 segments of numerical data)

Segment 1

Program a number from 0 -15 to represent the corresponding X-10 Module Number from the following table.

Default is 0.

Module

Seg 1

NX-1701E Installation manual