Table of Contents
Advertisement
VANTAGE 549
ACCESSORIES
wire feeDer options
LN-25 Ironworker™ Wire Feeder - Portable CV unit for flux-cored
and mig welding with maxtrac® wire drive system. includes
digital meters for wire feed speed/amperage and voltage, gas
solenoid, internal contactor and 5/64 in. (2.0 mm) drive roll kit for
cored wire. has 83% reduced wire feed speed capability for 6
o'clock pipe welding with Innershield® wire. K2614-9
POWER FEED 25M - This compact shop or construction wire
feeder is push-pull capable for premium aluminum welding.
Featuring our MAXTRAC® drive system, full controls and
procedural memory presets, the Power Feed® 25M is ready for
advanced process welding on almost any application.
K126™ PRO Innershield® Gun - For self-shielded wire with 15 ft.
(4.5 m) cable. For .062-5/64 in. (1.6-2.0 mm) wire. Includes
K466-10 Connector Kit. K126-12
KP1696-1 Drive Roll Kit - Includes: 2 V groove drive rolls and
inner wire guide for Steel Wires. (Used on LN-25 Pro)
Drive Roll and Guide Tube Kit - For .068-.072 in. (1.7-1.8 mm)
cored or solid steel wire. KP1697-068
Magnum® PRO 350 Ready-Pak® 15 ft., .035-5/64 in. Magnum®
PRO MIG/flux-cored welding guns are rated 100% duty cycle. The
guns are designed for high amperage, high duty cycle applications
in extreme environments where heat-resistance and fast service-
ability are key.
K2652-2-10-45
K487-25 Magnum SG Spool Gun - Hand held semiautomatic wire
feeder. Requires SG Control Module and Input Cable.
K488 SG Control Module - The Interface between the power
source and the spool gun. Provides control of the wire speed and
gas flow. For use with a spool gun.
K691-10 Input Cable (For SG Control Module) - For Lincoln engine
power sources with 14-pin MS-type connection, separate 115V
NEMA receptacles and output stud connections.
plasMa cUttinG
Tomahawk® 1000 - Cuts metal using the AC generator power
from the engine-driven welder. Requires the T12153-9 Full-KVA
Power Plug (1-Phase).
K2808-1
C-2
Advertisement
Table of Contents
