Setting Up Service Provider Connectivity At The Central Site - Paradyne FrameSaver SLV 9626 Installation Instructions Manual

Setting Up the Criteria for Automatic Backup
1. Enable Auto Backup.
Main Menu
When a failure occurs, the unit automatically enables the Alternate Link and traffic
is rerouted over the backup (alternate) interface.
2. Specify When Auto Backup Allowed – Always or Restrict. If Restrict is selected,
specify the days and hours of the week during which automatic backup can take
place.
3. Save the configuration.
Setting Up Service Provider Connectivity
at the Central Site
When management needs to be set up between a service provider's customer and its
network operations center (NOC), a non-multiplexed DLCI must be configured to carry
management data between the customer's central site and the NOC console. This
requires that a frame relay discovered DLCI needs to be modified. This is because all
auto-configured network DLCIs are configured as multiplexed DLCIs.
To set up NOC management:
1. Select DLCI Records on the network interface:
Configuration
2. Select Modify. The Modify DLCI Record for DLCI Number? prompt
appears.
3. Select the DLCI that will be used by pressing the spacebar until the correct DLCI
number appears, then select it.
4. Change the DLCI Type from Multiplexed to Standard.
The
DLCI in connections. Update DLCI usage as follows: prompt
appears.
5. Select the Delete EDLCI Connections and Make a Mgmt Only PVC
option.
PVC connections for the selected DLCI are broken, the Port-1 DLCI mapped to
this network DLCI and the embedded management DLCI (EDLCI) are deleted, and
the selected DLCI will be reconfigured as a management PVC using the Node IP
Address.
Configuration Auto Backup Criteria
Network DLCI Records
12