Top Vent Configuration With Horizontal Termination - Lopi 564 GSR2 25K CF Installation Manual

28 Finalizing the Installation

Top Vent Configuration with Horizontal Termination


The termination must fall within the shaded area shown in the chart. Use the indicated restrictor and
diffuser positions.

Up to four elbows (45° or 90°) may be used.

Use 8" vent.

Only one horizontal elbow may be used.
21' max (6.4m)
20 feet (6m)
15 feet (4.5m)
10 feet (3m)
5 feet (1.5m)
0 feet
This is considered a horizontal
elbow (it does not matter
whether it turns right or left).
It may be a 90° or 45° elbow.
© Travis Industries
Exhaust Restrictor # 5
Intake Restrictor # 2
Diffuser Position # 2
Exhaust Restrictor # 4
Intake Restrictor # 2
Diffuser Position # 2
Exhaust Restrictor # 1
Intake Restrictor # 1
Diffuser Position # 1
NOTE: If using an elbow with no vertical sections:
- Remove the Exhaust Restrictor (leave screws in place)
- Intake Restrictor # 1 (stock)
- Diffuser Position # 1 (stock)
H2
H1
5/15/2019 - 1508
(for qualified installers only)
Exhaust Restrictor # 2
Intake Restrictor # 1
Diffuser Position # 1
Horizontal length is calculated by adding
both lengths of horizontal run
(Horizontal Length = H1 + H2).
This is considered a
vertical elbow
564 GSR2 25K CF (AUST)
21' max (6.4m)
20 feet (6m)
15 feet (4.5m)
10 feet (3m)
5 feet (1.5m)
0 feet