Roland V-Drums TD-8 Owner's Manual page 207

System exclusive messages related to mode setting
Turn General MIDI System On
This is a command message that resets the internal settings of the unit to the General MIDI
initial state (General MIDI System - Level 1). After receiving this message, this unit will
automatically be set to the proper condition for correctly playing a General MIDI score.
Status Data byte
F0H 7EH, 7FH, 09H, 01H
Byte Explanation
F0H Exclusive status
7EH ID number (Universal Non-realtime Message)
7FH Device ID (Broadcast)
09H Sub ID#1 (General MIDI Message)
01H Sub ID#2 (General MIDI 1 On)
F7H EOX (End Of Exclusive)
* Not Received when [SETUP]-[MIDI]-[GLOBAL]-[PAGE 3] RX GM ON is set to
"OFF".(Initial Value is ON)
* There must be an interval of at least 50ms between this message and the next.
Turn General MIDI System Off
When a "GM System Off" is received, the TD-8 is switched to normal mode.
Status Data byte
F0H 7EH, 7FH, 09H, 02H
Byte Explanation
F0H Exclusive status
7EH ID number (Universal Non-realtime Message)
7FH Device ID (Broadcast)
09H Sub ID#1 (General MIDI Message)
02H Sub ID#2 (General MIDI 1 Off)
F7H EOX (End Of Exclusive)
* Not Received when [SETUP]-[MIDI]-[GLOBAL]-[PAGE 3] RX GM ON is set to
"OFF".(Initial Value is ON)
* There must be an interval of at least 50ms between this message and the next.
Universal Non-realtime System Exclusive Messages
Identity Request
* Regarding the Identity Request refer to p. 202.
Global Parameter Control
Channel Pressure
Status Data byte
F0H 7FH, dev, 09H, 01H, 0nH, ppH, rrH
Byte Explanation
F0H Exclusive status
7FH ID number (Universal Realtime Message)
dev Device ID (dev: 00H - 1FH Initial value is 10H (17))
09H Sub ID#1 (Controller Destination Setting)
01H Sub ID#2 (Channel Pressure)
0nH MIDI channel (00H - 0FH)
ppH parameter
rrH range
F7H EOX (End Of Exclusive)
pp=0 Pitch Control
rr=28H-58H -24 - +24 semitones
pp=1 Filter Cutoff Control
rr=00H-7FH -9600 - +9450 cents
pp=2 Amplitude Control
rr=00H-7FH 0 - 200%
pp=3 LFO Pitch Depth
rr=00H-7FH 0 - 600 cents
pp=4 LFO Filter Depth
rr=00H-7FH 0 - 2400 cents
pp=5 LFO Amplitude Depth
rr=00H-7FH 0 - 100%
* Even if the Device ID is 7FH (Broadcast), Identity Reply message will be transmitted.
* In the rhythm part (ch.10), ignored this message.
Status
F7H
Status
F7H
Status
F7H
Data transmission
Request data 1 RQ1 (11H)
* Regarding the RQ1 refer to p. 202.
Data set 1 DT1 (12H)
* Regarding the DT1 refer to p. 203.
Section 2. Transmit data
* When [SETUP]-[MIDI]-[GLOBAL]-[PAGE 3] SOFT THRU is set to "ON", messages
received in addition to the following messages are also sent.
Active sensing
Status
FEH
* This will be transmitted constantly at intervals of approximately 250ms.
System exclusive messages
Universal Non-realtime System Exclusive Messages
Identity Reply
* Regarding the Identity Reply refer to p. 205.
Data Transmission
Data set 1 DT1 (12H)
* Regarding the DT1 refer to p. 205.
MIDI Implementation
207