Checking The Tones And Phrases During Realtime Recording (Rehearsal Function); Deleting Unneeded Data During Realtime Recording (Realtime Erase); Set The Tempo - Roland V-Drums TD-8 Owner's Manual

Chapter 5 Playing Along with Patterns
LOOP ALL:
The entire pattern will be repeated, and on each pass
your performance will be added ("overdubbed"), and
mixed with what you did previously.
LOOP 1, LOOP 2:
This determines the length of the section you are
recording, and 1 or 2 measure sections will repeat.
REPLACE:
Recording will continue until you press [PLAY/STOP].
Any previously recorded data for all Parts will be erased.

6. Set the tempo

Press [TEMPO] if you are recording at a tempo different than
2
the tempo set in Step .
fig.06-036
1. Press [TEMPO].
[TEMPO] lights, and the "TEMPO" screen appears.
2. Press [INC/+] or [DEC/-] or rotate the VALUE dial to
select the tempo.
3. When you have finished making the settings, press
[TEMPO].
The [TEMPO] light goes out, and the "TEMPO" screen is
removed from the display.
7. Recording
fig.06-037
1. Press [PLAY/STOP] to begin recording.
[PLAY/STOP] stops flashing and remains lit, and
recording begins.
The "REC" screen appears.
2. Play with pads or MIDI keyboards to record.
3. Press [PLAY/STOP] to stop recording.
The [PLAY/STOP] and [REC] lights go out.
110
Checking the Tones and Phrases
During Realtime Recording
(REHEARSAL FUNCTION)
The Rehearsal function is a feature that temporarily
suspends recording during Realtime Recording. This allows
you to check the next instrument or phrase to be recorded
while recording is in progress.
fig.06-038
1. Start Realtime Recording (p. 108).
2. While the recording is underway, press [REC].
[REC] flashes, and the "REC REHEARSAL" screen is
displayed.
At this point, performances of the pads or external MIDI
keyboard cannot be recorded.
3. Press [REC] to resume recording.
[REC] lights.
Deleting Unneeded Data During
Realtime Recording
(REALTIME ERASE)
Realtime Erase is a function that deletes unneeded data
during Realtime Recording.
ig.06-039
1. Start Realtime Recording (p. 108).
Set the "REC MODE" (p. 109) to "LOOP ALL", "LOOP 1",
or "LOOP 2".
2. While the recording is underway, hold down [SHIFT],
and press [REC].
The "REALTIME ERASE" screen is displayed.
3. Press CURSOR [
] to move the cursor to "PART."
4. Press [INC/+] or [DEC/-] or rotate the VALUE dial to
select the part from which data is to be erased.
5. Press CURSOR [
] to move the cursor to "ERASE."
6. Press [INC/+] or [DEC/-] or rotate the VALUE dial to
choose the delete part.