Others - Roland Sound Canvas SC-8850 Owner's Manual

30: Fb P.Shifter (Feedback Pitch Shifter)
This pitch shifter allows the pitch shifted sound to be
returned into the effect.
fig.9-33
L
Pitch
R
+P.Coarse (Coarse Pitch)
Adjusts the pitch of the pitch shifted sound in semitone
steps (-2–+1 octaves).
P.Fine (Fine Pitch)
Make fine adjustsments to the pitch of the pitch shifted
sound in 2-cent steps (-100–+100 cents).
#Feedback (Feedback Level)
Adjusts the proportion (%) of the processed sound that is
fed back into the effect. Negative (-) settings will invert the
phase.
Pre Dly (Pre Delay Time)
Adjusts the time delay from when the direct sound begins
until the pitch shifted sound is heard.
Mode (Pitch Shifter Mode)
Higher settings for this parameter will result in slower
response, but steadier pitch.
EFX Pan (Effect Output Pan)
Adjusts the stereo location of the pitch shifted sound. L63 is
far left, 0 is center, and R63 is far right.
Balance (Effect Balance)
Adjusts the volume balance between the direct and the
processed sound.
"D" or "E" on the display respectively means D (direct
sound) or E (effect sound) values of 100.
Low Gain
Adjusts the gain of the low frequency range.
Hi Gain (High Gain)
Adjusts the gain of the high frequency range.
Level (Output Level)
Adjusts the output level.
[01H, 61H]
EQ
Balance
Pan
EQ
-24–0–+12 [1 (40 03 03)]
-100–0–+100 [2 (40 03 04)]
-98%–+98% [3 (40 03 05)]
0–100ms [4 (40 03 06)]
1–5 [5 (40 03 07)]
L63–0–R63 [6 (40 03 08)]
D>0E–D0<E [16 (40 03 12)]
-12–+12 [17 (40 03 13)]
-12–+12 [18 (40 03 14)]
0–127 [20 (40 03 16)]

Others

31: 3D Auto
The 3D Auto effect rotates the location of the sound.
fig.9-34
L
3D Auto
R
Azimuth
Sets the location at which the sound will stop when rotation
is stopped.
A setting of 0 positions the sound in the center.
+Speed
Sets the speed of rotation.
Clockwise
Sets the direction of rotation. A setting of - is counter-
clockwise, and + is clockwise.
#Turn
This stops or starts the rotation. When this is turned On, the
sound will rotate. When turned Off, rotation will stop at the
location specified by Azimuth.
Out (Output Mode)
Specifies the method that will be used to hear the sound
that is output to the OUTPUT jacks. The optimal 3D effect
will be achieved if you select Speaker when using speakers,
or Phones when using headphones (p.128).
Level (Output Level)
Adjusts the output level.
Using Insertion Effects
[01H, 70H]
180/L168–0–R168 [1 (40 03 03)]
0.05–10.0 [2 (40 03 04)]
-/+ [3 (40 03 05)]
Off/On [4 (40 03 06)]
Speaker/Phones [15 (40 03 11)]
0–127 [20 (40 03 16)]
105