Mastering Effect - Roland MC-808 Sound List

47: TIME SKIP DELAY
A delay that changes the delay time in stair-step fashion.
fig.MFX47
L in
Balance D
Time Skip Delay
Feedback
R in
Balance D
Parameter Value
Delay #1 0–4000 ms,
note
Skip Rate 0.05–10.0
Hz, note
Feedback -98– +98 %
#2
Accelera- 0–15
tion
HF Damp 200–8000
Hz, BY-
PASS
Pan L64–63R
Low Gain -15– +15 dB
High Gain -15– +15 dB
Balance D100:0W–
D0:100W
Level 0–127
note:
fig.notelist2.e
(Sixty-fourth-note triplet), (Sixty-fourth note),
(Sixteenth-note triplet),
(Thirty-second note),
(Eighth-note triplet),
(Sixteenth note),
(Eighth note), (Quarter-note triplet),
(Quarter note), (Half-note triplet),
(Whole-note triplet), (Dotted half note),
(Double-note triplet), (Dotted whole note),
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ
Description
Adjusts the time until the delay is
heard.
Frequency at which the delay time
will change
Adjusts the amount of the delay
sound that's fed back into the effect.
Negative (-) settings invert the
phase.
Adjusts the time over which the De-
lay Time changes from the current
setting to its specified new setting.
Adjusts the frequency above which
sound fed back to the effect is fil-
tered out. If you don't want to filter
out any high frequencies, set this
parameter to BYPASS.
Stereo location of the delay
Gain of the low frequency range
Gain of the high frequency range
Volume balance between the direct
sound (D) and the delay sound (W)
Output level
(Thirty-second-note triplet),
(Dotted thirty-second note),
(Dotted sixteenth note),
(Dotted eighth note),
(Dotted quarter note), (Half note),
(Whole note),
(Double note)
Effects editing parameters

Mastering effect

Parameter Range
ATTACK 0–100 ms
RELEASE 50–5000 ms
THRESHOLD -36–0 dB
RATIO 1.00:1–
INF:1
LEVEL 0–24 dB
Split Frequency 2000–8000
High Hz
Split Frequency 200–800 Hz
Low
About THRESHOLD and RATIO
As shown in the diagram below, these parameters determine how
the volume is to be compressed.
fig.Comp.e
THRESHOLD
Explanation
Time from when the volume
goes up THRESHOLD until the
compressor effect applies
Time from when the volume
falls below THRESHOLD until
the compressor effect no longer
applies
Volume level at which com-
pression begins
Compression ratio (INF: infini-
ty)
Output volume
Frequency at which the high-
frequency (HI) and mid-fre-
quency (MID) bands are split
Frequency at which the low-
frequency (LO) and mid-fre-
quency (MID) bands are split
1:1
RATIO
2:1
4:1
INF:1
Input Level
43