Guitar Amp Simulator - Roland MC-808 Sound List

Parameter Value
Depth 0–127
Feedback -98– +98 %
#2
Step Rate 0.10–20.00
#1 Hz, note
Phase 0–180 deg
Low Gain -15– +15 dB
High Gain -15– +15 dB
Balance D100:0W–
D0:100W
Level 0–127
23: OVERDRIVE
Creates a soft distortion similar to that produced by vacuum tube
amplifiers.
fig.MFX23
L in
Over Amp
drive Simulator
R in
Parameter Value
Drive #1 0–127
Tone #2 0–127
Pan L64–63R
Amp Sw OFF, ON
Amp Type SMALL,
BUILT-IN,
2-STACK,
3-STACK
Low Gain -15– +15 dB
High Gain -15– +15 dB
Level 0–127
24: DISTORTION
Produces a more intense distortion than Overdrive. The parameters
are the same as for "23: OVERDRIVE."
fig.MFX24
L in
Amp
Distortion
Simulator
R in
Description
Depth of modulation
Adjusts the amount of the flanger
sound that's fed back into the effect.
Negative (-) settings invert the
phase.
Rate (period) of pitch change
Spatial spread of the sound
Gain of the low frequency range
Gain of the high frequency range
Volume balance between the direct
sound (D) and the flanger sound
(W)
Output level
L out
Pan L
2-Band
EQ
Pan R
R out
Description
Amount of distortion
Also changes the volume.
Sound Quality
Stereo location of the OVERDRIVE
output
Amp simulator on/off
Type of guitar amp
SMALL: small amp
BUILT-IN: single-unit type amp
2-STACK: large double-stack amp
3-STACK: large triple-stack amp
Gain of the low frequency range
Gain of the high frequency range
Output level
L out
Pan L
2-Band
EQ
Pan R
R out
Effects editing parameters
25: GUITAR AMP SIM

(Guitar Amp Simulator)

This is an effect that simulates the sound of a guitar amplifier.
fig.MFX25
L in
Pre Amp
R in
Parameter Value
Pre Amp OFF, ON
Sw
Pre Amp JC-120,
Type Clean Twin,
Match Drive,
BG Lead,
MS1959I,
MS1959II,
MS1959I+II, SLDN
Lead, Metal 5150,
Metal Lead,
OD-1, OD-2 TURBO,
Distortion, Fuzz
Pre Amp 0–127
Volume #1
Pre Amp 0–127
Master #2
Pre Amp Low, Mid, High
Gain
Pre Amp 0–127
Bass
Pre Amp
Middle
Pre Amp
Treble
Pre Amp 0–127
Presence (MATCH DRIVE:
-127 - 0)
Pre Amp OFF, ON
Bright
Speaker Sw OFF, ON
Speaker (See the following
Type table.)
Mic Setting 1, 2, 3
Mic Level 0–127
Direct Lev- 0–127
el
Pan L64–63R
Level 0–127
L out
Pan L
Speaker
Pan R
R out
Description
Turns the amp switch on/
off.
Type of guitar amp
Volume and amount of dis-
tortion of the amp
Volume of the entire pre-
amp
Amount of pre-amp distor-
tion
Tone of the bass/mid/tre-
ble frequency range
* Middle cannot be set if
"Match Drive" is selected
as the Pre Amp Type.
Tone for the ultra-high fre-
quency range
Turning this "On" produc-
es a sharper and brighter
sound.
* This parameter applies to
the "JC-120," "Clean
Twin," and "BG Lead"
Pre Amp Types.
Determines whether the
signal passes through the
speaker (ON), or not (OFF).
Type of speaker
Adjusts the location of the
mic that's capturing the
sound of the speaker.
This can be adjusted in
three steps, from 1 to 3,
with the mic becoming
more distant as the value
increases.
Volume of the microphone
Volume of the direct sound
Stereo location of the out-
put
Output level
35