Preparing The Remote - Hunter 51475 Installation Manual

For your convenience, a remote function card
is packed in with your remote.
To access the battery compartment,
remove the the battery door to the
transmitter assembly.
ON
Battery
Door
Install two AAA batteries, found in the remote control
hardware bag, into the transmitter. Clean the battery
contacts prior to installing the batteries. Please contact
your local battery recycling center for proper battery
disposal information.
You have two options for installing the remote cradle.
Choose which path works best for you.
Option 1: Using Adhesive Strip
Separate the lining
from the back of the
Remove the cradle from
adhesive strip on
the cradle bracket.
the cradle bracket.
Ceiling Bracket Hanging Fan

Preparing the Remote

IMPORTANT
• Always purchase the
correct size and grade of
battery most suitable for
the intended use.
• Replace all batteries of a
set at the same time.
• Clean the battery contacts
and also those of the
device prior to battery
installation.
• Ensure the batteries are
installed correctly with
regard to polarity (+ and -).
• Remove batteries from
equipment which is not to
be used for an extended
period of time.
• Remove used batteries
promptly.
Installing the Remote Control Cradle
Press the cradle
bracket against the
wall and hold firmly
for 30 seconds.
Wiring Canopy
Fan On/Off
Fan Speed Up
Fan Speed
Down
The Fan On/Off button turns
the fan on or off. Adjust the
fan speed using the "Fan
Speed Up" or "Fan Speed
Down" directional buttons.
NOTICE
: DIMMING MODE
To enable dimming, your remote must be set to
Dimming Mode. To toggle Dimming Mode on or off,
long press the "Fan Speed Up" button and "Fan
Speed Down" button.
Option 2: Using Screws
Choose your cradle
installation location.
If you are installing into drywall, drill two
9/64 width holes using the cradle bracket
as a guide. Gently hammer the included
drywall anchors into the pre-drilled holes.
Blades Light
The remote transmitter is already
paired to the receiver and ready to use.
Dimming mode is off by default.
Note: If you need to pair your remote,
turn fan power off and back on at the
wall switch. Within 3 minutes, press
and release the "PAIR" button on the
back of the remote. Do not hold down
the button. To prevent faulty operation,
please ensure all other ceiling fans
within range are turned off at the wall
switch while pairing.
Quick Press:
Light On/Off
Long Press:
Light Dimming
Quickly press the Light button to turn
the lights off and on. Hold the Light
button to raise and dim the light level.
Slide the cradle onto
the mounted bracket.
Bulbs Remote
1886
8