Preparing The Remote - Hunter Malden Installation Manual

1886
The remote control is
already paired for use. For
your convenience, a remote
function card is packed in
with your remote.
NOTICE
• Always purchase the correct size and grade of
battery most suitable for the intended use.
• Replace all batteries of a set at the same time.
• Clean the battery contacts and also those of the
device prior to battery installation.
• Ensure the batteries are installed correctly with
regard to polarity (+ and -).
• Remove batteries from equipment which is not to
be used for an extended period of time.
• Remove used batteries promptly.
9
Ceiling Bracket

Preparing the Remote

Downrod Hanging Fan
To access the battery
compartment, remove the
small Phillips head screw that
secures the battery door to
the transmitter assembly. The
battery should be installed
with the positive (+) side
up. Replace with a CR2032
battery when necessary.
Battery
Door
Phillips
Head
Screw
Wiring
Remote Function Guide
Key Press Function
+ Quick Press Fan On/Off
+ Quick Press Low Speed
+ Quick Press Medium Speed
+ Quick Press High Speed
MA578-01
Blades Switch Housing
ON
Remote