Preparing The Remote - Hunter Interface 51353 Installation Manual

1886
The remote control is
already paired for use. For
your convenience, a remote
function card is packed in
with your remote.
NOTICE
• Always purchase the correct size and
grade of battery most suitable for the
intended use.
• Replace all batteries of a set at the same
time.
• Clean the battery contacts and also those
of the device prior to battery installation.
• Ensure the batteries are installed
correctly with regard to polarity (+ and -).
• Remove batteries from equipment which
is not to be used for an extended period
of time.
• Remove used batteries promptly.
You have two options for installing the remote cradle.
Choose which path works best for you.
Option 1: Using Adhesive Strip
Separate the lining
from the back of the
Remove the cradle from
adhesive strip on
the cradle bracket.
the cradle bracket.
9
Ceiling Bracket

Preparing the Remote

To close the battery
compartment, secure
the battery door to the
transmitter assembly with
the small Phillips head screw.
Replace with a CR2032
battery when necessary. The
battery should be installed
with the positive (+) side up.
Installing the Remote Control Cradle
Press the cradle
bracket against the
wall and hold firmly
for 30 seconds.
Hanging Fan Wiring
Key Press
+ Quick Press
+ Long Press
+ Quick Press
+ Quick Press
+ Quick Press
Battery
Door
Long Press
Long Press
Long Press
Long Press
Phillips
Long Press
Head
Screw
Option 2: Using Screws
Choose your cradle
installation location.
If you are installing into drywall, drill two
9/64 width holes using the cradle bracket
as a guide. Gently hammer the included
drywall anchors into the pre-drilled holes.
Blades Light
Function
Light On/Off
Light Dimming
Fan On/Off
Raise Fan
Speed
Lower Fan
Speed
+ Fan Updraft
Fan Downdraft
+
+ Enable Beep
+ Disable Beep
Dimming Mode
+
On/Off
ON
Slide the cradle onto
the mounted bracket.
Remote Troubleshooting App