Table of Contents
Advertisement
Design
•Install the Inverter in a clean location free from oil mist and dust. Alternatively, install it
in a totally enclosed panel that is completely shielded from suspended dust.
•When installing or operating the Inverter, always take special care so that metal pow-
der, oil, water, or other foreign matter do not get in the Inverter.
•Do not install the Inverter on inflammables such as wood.
H Direction of Installation
•Install the Inverter on a vertical surface so that the characters on the nameplate are
oriented upward.
H Installation Space
•When installing the Inverter, always provide the following installation space to allow
normal heat dissipation from the Inverter:
H Ambient Temperature Control
•To enhance operation reliability, the Inverter should be installed in an environment free
from extreme temperature rises.
•If the Inverter is installed in an enclosed environment such as a box, use a cooling fan
or air conditioner to maintain the internal air temperature below 50°C.
•The surface temperature of the Inverter may reach 30°C higher than the ambient tem-
perature. Therefore, keep all thermally susceptible devices and wires away from the
Inverter.
H Protecting the Inverter from Foreign Matter during Installation
•Place a cover over the Inverter to shield it from metal powder produced by drilling dur-
ing installation.
(Upon completion of installation, always remove the cover from the Inverter. Other-
wise, ventilation will be affected, causing the invert to overheat.)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
W= 30 mm min.
100 mm min.
Air
Side
100 mm min.
Air
Chapter 3
3-5
Advertisement
Table of Contents
