Rimage Everest III User Manual page 202

Rimage everest iii: user guide
Hide thumbs Also See for Everest III:
Table of Contents

Advertisement

安全試験
製品名:Everest III プリンタ
モデル:CDPR22
Notice for USA
Federal Communications Commissions (FCC) Warning
Any unauthorized modification to this equipment may result in the
revocation by the FCC of the user's authority to operate this equipment.
Federal Communications Commissions (FCC) Notice
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
This equipment complies with FCC/IC radiation exposure limits set forth for
uncontrolled equipment and meets the FCC/IC radio frequency (RF)
Exposure Guidelines in Supplement C to OET65. This equipment has very
low levels of RF energy that is deemed to comply without maximum
permissive exposure evaluation (MPE). But it is desirable that it should be
installed and operated with at least 8 in (20 cm) or more between the
radiator and the person's body (excluding extremities: hands, wrists, feet
and legs).
Additional FCC Notices
Properly shielded and grounded cables and connectors must be used for
connection to host computer and/or peripherals in order to meet FCC
emission limits.
Safety precautions for RF exposure
This transmitter must not be co-located or operated in conjunction with any
110875_B110875_B
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Rimage™注意と警告
47

Advertisement

Table of Contents
loading

Table of Contents