Rimage Everest Encore Setup And Installation Manual

Rimage Everest Encore
® ™
Installation Guide
Before You Begin:
This guide provides the information needed to set up a standalone Everest Encore
printer. The instructions in this document are intended for people who are familiar with
hardware setup, software installation, and Windows operating systems. If you do not
understand the procedures in this document, ask your computer technician for help.
-
Important!
• If your Everest printer is part of an autoloader system, including Producer V,
or Catalyst systems, refer to your autoloader's setup and installation guide for
instructions on setting up the Everest printer.
• If your Everest printer is part of an AutoPrinter, refer to the Rimage AutoEverest
Setup and Installation Guide.
• Documents referenced in this procedure are available online at
www.rimage.com/support.
• Read all setup instructions thoroughly before you begin.
• Save all packing boxes and packing materials for use if the printer ever needs to
be shipped.
 Notes:
• The terms "Everest" and "printer" are used throughout this document to refer
to the Everest Encore.
• Unless otherwise indicated, all Windows navigation statements are Windows 10
paths. Other Windows operating systems' navigation may differ slightly.
• Your product may not look exactly like the product pictured.
# Required tools: Phillips screwdriver
2004012_A
Setup and
1
Prepare the Everest Printer
a. Unpack the Everest printer. Refer to the
unpacking label on the printer box for
instructions.
b. Set the AC voltage switch.

c. Move the shipping screw.
i.
ii.
d. Press the two side cover latches.
e. Lower the side cover.
f. Inside the printer, open latches 1, 2,
and 3 as indicated by the arrows.
g. Remove the plastic packing
pieces from inside the printer.
Note: Follow the instructions on
the instruction card on the rear of
the printer.
On the rear of the Everest printer,
use a Phillips screwdriver to
remove the shipping screw from
the shipping position.
Shipping
Insert the shipping screw into the
Position
storage position.
Side Cover Latches
Latch 1
Latch 2
Plastic Packing Pieces
Copyright © 2017 Rimage Corporation
2
Install the Print Ribbon
a. Grasp the handle and pull to remove the
print ribbon carrier all the way out of the
printer.
b. Lay the print ribbon carrier on its back.
c. Wrap the print ribbon around the guide
AC Voltage
Switch rollers, as shown.
d. Snap the supply roll and take-up roll into
the print ribbon carrier.
Instruction
Card
e. Tighten the print ribbon by turning the
take-up roll clockwise.
Storage
f. Insert the print ribbon carrier into the
Position
printer.

Note: Do not close the latches yet.
3
Install the Retransfer Ribbon
a. Grasp the handle to slide the retransfer
ribbon carrier out of the printer.
b. Slide the retransfer ribbon under
the retransfer ribbon carrier.
 Note: The ribbon winds under
the supply roll, as shown.
Latch 3
c. Snap the supply roll and take-up roll
onto the carrier.
d. Tighten the retransfer ribbon
by turning the takeup roller
counterclockwise.
e. Slide the retransfer ribbon carrier
into the printer.
f. Close latches 1, 2, and 3, as
indicated by the arrows.
g. Close the printer side cover.
Print Ribbon Carrier
Guide Rollers
Supply
Take-up
Roll
Roll
Retransfer
Ribbon Carrier
Supply Roll Take-up Roll
Latch 1
Latch 2
Latch 3
Page 1