Rimage DL5200 Replacement Procedure page 8

0BReplace a Recorder on a Rimage DiscLab System
c. Position the right side cover on the DiscLab.
Important! The right side cover on some DLN5200 autoloaders has an air vent. If you are working on
a DLN5200 and there is an air vent, position the air vent as shown in the center photo.
d. Insert and tighten the Torx T10 screws (Qty. DL5200/DLN5200 = 8, DL = 4) to secure the right side cover.
DL5200
7. Connect the power cord to the power outlet.
Update the Rimage Software
Important! Install the appropriate service pack included with the recorder. This ensures that the new recorder
is supported by your Rimage system.
If no service pack software was included with the recorder, make sure that you have the most recent service
pack already installed.
Service packs and instructions are available at
Support – Rimage product > Downloads tab.
Support information
Europe
Contact Rimage Services Europe:
www.rimage.com/support.html
Email: support@rimage.de
Tel: +49-(0) 6074-8521-0
US, Asia/Pacific, Mexico/Latin America
Contact Rimage Services:
www.rimage.com/support.html
Email: http://www.rimage.com/support_form.cfm
Tel: North America: 800-553-8312
Asia/Pacific, Mexico/ Latin America: 952-946-0004
2000122_D
DiscLab™, DL5200™ and DLN5200™
Air Vent
Right Side Cover
DLN5200
www.rimage.com/support.html
When you contact Rimage Services, please provide:
•
Unit serial number and software version.
•
Functional and technical description of the problem.
•
Exact error message received.
Rimage Corporation reserves the right to make improvements to the
equipment and software described in this document at any time without
any prior notice. Rimage Corporation reserves the right to revise this
publication and to make changes from time to time in the content hereof
without obligation of Rimage Corporation to notify any person or
organization of such revisions or changes.
© 2008, Rimage Corporation
DiscLab
. Navigate: Product Family >
8